Daily Archives: January 22, 2019

Garage Door Installation Instructions

Published by:


The garage door installation instructions detailed below are just basic and aren’t a complete set of instructions. You should consult your installation manual for total full guidelines. But mounting a garage door isn’t as hard as some may believe. It takes having the ability to comply with sensible steps and taking them in order. The very first agenda are the dimensions.

You’ll need to have some precise dimensions prior to you can get going. They’ll assist determine what size door you need and ought to be composed down so you will not neglect them. First, take the height and width of the door opening. This will certainly give you your starting factor for your numbers and once more, will certainly show what your door dimension will certainly be.


Next step is identifying your ‘side-room’. This is the area from the side of your door to the garage wall surface on that exact same side. You vertical track for your common extension spring and torsion spring, is mosting likely to call for that you contend the very least 3-3/4 from the side. Then for the extension spring you’ll require to have 5-1/2.

Your next dimension will be for determining your ‘head-room’. This will be the quantity of room beginning at the top of the door up to the ceiling. In this instance, for an expansion spring you’re mosting likely to need 10, and 12 for the torsion spring. If you face a circumstance where you have actually limited headroom, after that there is special hardware made simply for that celebration. You’ll need a lot more headroom if you intend to install a garage door opener.

It’s time currently to get the numbers for the ‘back-room’. This will certainly be the room that exists between the garage door opening right to the rear of the garage wall. This should amount to whatever the height of your door is, plus an additional eighteen inches. And simply as above, if you prepare to place in a garage door opener, then you’re going to require even more space.


Having your measurements taken and documented, you can currently get the door opening up prepared for installation. On the within of the door opening, you must have a framework of 2×6 timber jambs. This timber should match the elevation of the clearance you measured simply a little bit previously. They should be level and plumb, and the wood if old should be replaced with new. Ensure if there are any type of screws, that the heads are down flush and not protruding where they might enter your way when mounting your brand-new door.

Currently we come to the sections. The bottom area obtains ready initially. Get your hardware and put it in groups on the garage floor. Attach your weatherstripping down section. This is best done on top of saw horses. This is where you need to follow your handbook to a “T” due to the fact that not all garage doors are exactly alike. Yet this is the place where the lift wire obtains attached in addition to joints and your support strut.

Again, this is simply garage door installation laid out and not a precise detailed direction for any type of particular brand. Every one features it’s own guidebook, yet this article will offer you some idea concerning what may be included if you’re considering installing one on your own. It’s truly not tough once you get going. From this point you merely connect the other sections and your deal with, driving 3 nails right into your wooden jambs on each side to hold the sections in position. You can never ever underestimate your installation manual.